HOTWATER – Monoblock 80 litre – DUCTED Kitchen series

TWMMS 09080 J - TWMMS 09100 J- TWMMS 09150 J

Typology

Indoor unit, Monoblock

Solution

Domestic hot water

Applications

Office, Store, Whole house

Heating system

Heat pump water heater

Share this product:

HOT WATER 80 LITRE DUCTED KITCHEN SERIES

MONOBLOCK HEAT PUMP WATER HEATER, DESIGNED TO BE INSTALLED INSIDE THE TALL CABINETRY OF THE KITCHEN

  • R134A refrigerant gas
  • Magnesium anode
  • Energy Efficiency Class A++

  • COP 3.04*

  • Hot water up to 60°C with compressor only
  • Anti-Legionella cycle
  • Outstanding corrosion resistance
  • Exceptional resistance to corrosion thanks to Duplex technology

  • * According to EN 16147

Features

A++

Energy class

R134A

Refrigerant gas

> 60°C

Temperature with only the compressor

80L

Maximum tank capacity

Comfort at home

Designed to be installed in the kitchen, just like a traditional boiler, the ”Ducted Kitchen” series is conveniently placed inside the tall cabinetry of the kitchen, with air extraction to the outside.

Safety

  • The tank is made of Duplex, an extremely strong and corrosion-resistant variety of stainless steel.

  • Anti-legionella system: the danger of legionella bacteria is averted thanks to periodic cycles that raise the temperature of the water inside the storage tank above 65°C.

2 installation modes:

  • Installation with internal air intake: with air extraction outdoors.

  • External air installation: with air intake and expulsion to the outdoors.

Installation warnings

  • It is mandatory to install a safety and non-return valve on the cold-water inlet. Failure to do so could seriously damage the equipment. Use a valve with a 0.7 MPa setting. For the installation location, please refer to the piping connection diagram.
  • The discharge pipe of the safety valve must descend vertically and must not be placed in an environment where there is a risk of freezing.
  • The water must be able to drip freely from the pipe and its end must be left free.
  • The safety valve must be tested regularly to check its function and to remove any limescale that might block it.